Cup Face 360°
No face welds - the entire face is the
sweet spot. Every shot feels like dead center.
It may only be a few
millimeters on the face, but hitting the ball off-center instead of
direct-center usually means chipping instead of putting. Cup Face 360°
technology makes the entire beta-titanium face a sweet spot. The 3-D plasma
welding is completely off the face, enabling maximum rebound properties over a
larger hitting area. It's a sweet spot that is 30% larger than normal insert
technology. So every shot feels like you hit it dead center. And the edge of the
face can put you a long way down the middle.
Beta-Titanium Crown Insert
Lowers CG dramatically.
Very low spin. Optimal launch.
Alpha, alpha-beta and beta: Like the
three grades of gasoline, there are three grades of titanium. Beta-titanium is
high-octane supreme. MacGregor uses 15-3-3-3 beta-titanium to fashion an
incredibly thin (.4mm) and light crown insert. This is 60% less mass than a
standard titanium crown (1mm) and allows MacGregor to redistribute extra weight
to the sole. This dramatically lowers the CG by 12% and helps achieve the
ultimate in driver design: ultra-low spin combined with an optimal launch angle.
Think long in the air and even longer once the ball lands. Yes, beta-titanium is
expensive, but better materials always are. |
|
Loft |
Lie |
Face Angle |
Bias |
Swing Weight &
Torque |
|
Regular |
Stiff |
X-stiff |
| 8° |
59° |
1.5° Open |
Fade |
D1
& 3.5° |
D2
& 3.0° |
D2 & 2.5° |
| 9° |
59° |
1.0° Open |
Neutral |
D1
& 3.5° |
D2
& 3.0° |
D2 & 2.5° |
| 10° |
59° |
1.0° Open |
Slight Draw |
D1
& 3.5° |
D2
& 3.0° |
D2 & 2.5° |
| HL
10° |
59° |
1.0° Open |
Slight Draw |
D1
& 3.5° |
D2
& 3.0° |
D2 & 2.5° |
- Shaft Length: 44.75
- Grip: Golf Price New Decade
Multicompound
|